Matching String & Location - Metapace S-2 Hardware Manual

Metapace S-2 Hardware Manual
6.3.3 MATCHING STRING & LOCATION
By default, no matching string is specified, and therefore, it is disabled. You may enable
this feature by specifying a matching string; up to four characters are allowed.
When the Matching String Location is zero, the scanner will only check for the
existence of the matching string in the barcode data.
You may specify a value from 1 to 254 to indicate where the matching string starts in
the barcode data.
1) Read the label to specify a matching string.
2) Read the "
Hexadecimal Value
3) Read the "Validate" label to complete this setting.
4) Read the label to specify the location of the matching string.
5) Read the "
Decimal Value
6) Read the "Validate" label on the same page to complete this setting.
170
Matching String ...
" label on page 196 for the desired character string.
Location of
Matching String ...
" label on page 195 for the desired location.
End Programming Format