Reference And Specifications; Error Messages; Messages During Operations - Tascam Professional CD-RW900 Owner's Manual

8-Reference and specifications

Error messages

Message Details / response
Cannot record. Either erase the contents of the disc (for a CD-RW), or use a different recordable disc.
Can't Rec!
The disc has malfunctioned. Please replace with a new disc.
Disc Error!
No recording time remaining, or no recordable track is left on the disc.
Disc Full!
No space to input the letters.
Text Full!
The text data is not written on the disc yet. Open the tray to cancel the text you entered or
Sure? Text!
perform the finalize operation to write the data to the disc.
There is a problem in the drive.
Drive Error!
The digital input is not connected. Turn on the power of the equipment connected to DIGITAL IN.
D-IN UNLOCK!
There is no audio signal from DIGITAL IN.
Not Audio!
An error occurred while erasing.
Erase Error!
The sampling frequency of the digital input is not 44.1 kHz. Please turn the SRC on.
Not Fs44.1k!
There is no program.
PGM Empty!
No new programs can be created.
PGM Full!
Editing cannot be performed due to operational restrictions.
Can't Edit!
Menu selection cannot be performed due to selection restrictions.
Can't sel!
There was an error during recording. Please re-record.
Rec Error!
There is no directory that contains a file.
No DIR!
The MP3 file cannot be played back.
Decode Err!
The disc is in a format that the CD-RW900 cannot read.
Format Err!

Messages during operations

Message Statement
A blank recordable disc has been inserted.
Blank Disc
An operation such as finalize or erase has been successfully completed.
Complete
Calibration is being performed to operate recording properly.
Now OPC*
The disc is being repaired, and this operation will take a long time. Please do not turn off the
Disc Repair
power of the CD-RW900 until it finishes.
The recorded content is being written to the disc.
PMA Writing*
The table of contents data is being read.
TOC reading
*OPC=Optium power Control

TASCAM CD-RW900
*PMA=Program memory Area