Connecting The Vp-441 - Kramer VP-441 User Manual

5

Connecting the VP-441

!
i
To connect the VP-441, as illustrated in the example in
1. Connect an HDMI source (for example, a DVD player) to the HDMI 1 VIDEO
INPUT connector.
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-441 via a DVI-HDMI adapter. When using this adapter, you can
connect the audio signal via the terminal block connector
2. Connect a computer graphics source to the VGA 15-pin HD VIDEO INPUT
connector.
3. Connect a composite video source (for example, a composite video player)
to the CV VIDEO INPUT RCA connector.
4. Connect an s-Video source (for example, an s-Video player) to the YC 4-pin
VIDEO INPUT connector.
5. Connect a component video source (for example, a component video player)
to the COMP 1 P
6. Connect the audio input signals to the AUDIO IN terminal block connectors,
as required (not shown in
7. Connect the RGBHV VIDEO OUTPUT BNC connectors to an RGBHV
acceptor (for example, an RGBHV display).
8. Connect the HDMI VIDEO OUTPUT connector to an HDMI acceptor (for
example, a plasma display).
8
Always switch off the power to each device before connecting it to
your VP-441. After connecting your VP-441, connect its power and
then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
, P
R B
and Y, VIDEO INPUT RCA connectors.
Figure 3).
Figure 3, do the following:
VP-441 - Connecting the VP-441