Motorola APX 3000 Detailed Service Manual page 45
Hide thumbs
Also See for APX 3000:
- Basic service manual (144 pages) ,
- User manual (104 pages) ,
- Manual (59 pages)
Table of Contents
Advertisement
Theory of Operation: Main Board
3-19
To select the 800 RX VCO, pin E5 (GPO1) must be at a high logic level and pin D5 (GPO2) and pin
D6 (GPO8) must be at a low logic level. The output of the 800 RX VCO is then split into two signals.
One to the Prescaler buffer input and the other to the prebuffer input. The output of the prebuffer is
then fed to pin 1 (RFC) of U738. The output of U738, pin 5 (RF2) then goes to the pi attenuator
(comprised of R703, R704 and R707) and then fed to the receiver section via the RX_LO
transmission line.
To select the 700 TX VCO, pin E5 (GPO1) must be at a high logic level and pin D5 (GPO2) and pin
D6 (GPO8) must be at a low logic level. The output of the 700 TX VCO is then split into two signals.
One to the Prescaler buffer input and the other to the prebuffer input. The output of the prebuffer is
then fed to pin 1 (RFC) of U738. The output of U738, pin 4 (RF1) then goes to the transmit injection
buffer (comprised of Q774 and surrounding circuitry). The output of the transmit buffer, then goes to
the transmit section via the TX_INJ transmission line.
To select the 700/800 MHz TX VCO, pin D5 (GPO2) must be at a high logic level and pin E5 (GPO1)
and pin D6 (GPO8) must be at a low logic level. The output of the 700/800 MHz TX VCO is then split
into two signals. One to the Prescaler buffer input and the other to the prebuffer input. The output of
the prebuffer is then fed to pin 1 (RFC) of U738. The output of U738, pin 4 (RF1) then goes to the
transmit injection buffer (comprised of Q774 and surrounding circuitry). The output of the transmit
buffer, then goes to the transmit section via the TX_INJ transmission line.
To select the 800 TX VCO, pin D6 (GPO8) must be at a high logic level and pin E5 (GPO1) and pin
D5 (GPO2) must be at a low logic level. The output of the 800 TX VCO is then split into two signals.
One to the Prescaler buffer input and the other to the prebuffer input. The output of the prebuffer is
then fed to pin 1 (RFC) of U738. The output of U738, pin 4 (RF1) then goes to the transmit injection
buffer (comprised of Q774 and surrounding circuitry). The output of the transmit buffer, then goes to
the transmit section via the TX_INJ transmission line.
Advertisement
Table of Contents
Troubleshooting
