Preparation; Basic Connections - Panasonic KX-NT700 Operating Instructions Manual

Preparation

Basic Connections

This section explains all connections needed to make and receive IP line and TEL line calls.
To connect a Portable Station (PS) or computer to the unit, see page 41 or page 42, respectively.
1.
Connect the unit to the desired IP network and/or telephone line.
•
To connect to an IP network, connect a category 5 LAN cable to the LAN port and to a switching hub.
•
To connect to a telephone line, connect a telephone cord to the LINE jack and to a modular telephone
jack.
2.
Connect the AC adaptor cord of the included AC adaptor to the unit's DC input.
•
To use PoE (Power over Ethernet), connect the LAN cable to a PoE-compatible (IEEE802.3af)
switching hub or power supply. The included AC adaptor does not need to be connected when using
PoE.
•
If using an AC adaptor, use only the included AC adaptor (PQLV206).
•
Pass the AC adaptor cord through the groove on the bottom of the unit.
3.
Connect the AC adaptor to the AC outlet.
Note
•
The AC adaptor must remain connected at all times (unless the unit is powered by PoE). It is normal
for the adaptor to feel warm during use.
22 Operating Instructions
LINE LAN DC IN
A
B
C
A AC Adaptor Cord
B LAN Cable
C 2-conductor Telephone Cord
D To AC Outlet
E To Switching Hub
F
F Groove
D
G Telephone Jack or PBX
(RJ11C)
E
G
Document Version 2008/10