Programming The Unit; Changing And Confirming Settings; Changing Settings; Restarting The Unit - Panasonic KX-NT700 Operating Instructions Manual

Changing and
Confirming Settings
Settings can be programmed and confirmed from the
front panel. To use Conferencing Phone Manager
(found on the included CD-ROM) to program the unit
from a computer, see page 58.

Changing Settings

Using the Front Panel
1.
Press [MENU].
2.
Press [ ] or [ ] to select the desired programming
category, then press
3.
Press [ ] or [ ] to select the desired parameter,
then press .
SELECT
4.
Adjust the settings as desired.
•
To cancel without changing any settings, press
[MENU].
5.
Press .
SAVE
6.
Press [MENU].
Note
•
When programming the unit from the front
panel, the current setting is indicated on the
display by "ü".
•
To return to the previous screen, press
[BACK].
•
If you do not press any buttons for 1 minute, the
unit will return to standby mode.
•
The following parameters cannot be
programmed, and are therefore not displayed,
when the unit is in use.
–
Operation Mode
–
Language
–
Date & Time
–
Time Format
–
Ringer Volume
–
Ringtone
–
IP Network Settings (all parameters)
–
Protocol Settings (all parameters)
–
VoIP Settings (all parameters)
–
QoS Settings (all parameters)
Additionally, the following parameters cannot
be programmed, and are therefore not
displayed, when the TEL, PS, or PC line is in
use.
–
Line Selection
Document Version 2008/10
.
SELECT
–
TEL Settings (all parameters)
Using Conferencing Phone Manager
To use Conferencing Phone Manager (found on the
included CD-ROM) to program the unit from a
computer, see page 58.

Restarting the Unit

After changing the following parameters, the unit must
be restarted in order for the new settings to take effect.
(Data is not erased when the unit is restarted.)
–
Operation Mode (page 46)
–
IP Address Mode (page 49)
–
IP Address (page 50)
–
Subnet Mask (page 50)
–
Default Gateway (page 50)
–
SIP Ext. No. (page 50)
–
SIP Password (page 51)
–
SIP User Domain Name (page 51)
–
SIP Proxy Server IP Address (page 51)
–
SIP Registrar IP Address (page 51)
–
Hold Method (page 51)
–
SIP Signaling Port Number (page 52)
–
VLAN ID (page 53)
–
VLAN Priority (page 53)
–
SIP ToS Field (page 53)
–
RTP ToS Field (page 53)
1.
Press [MENU].
2.
Select "System Options", then press
3.
Select "Reboot", then press
4.
Select "Yes", then press
Note
•
To use Conferencing Phone Manager to restart
the unit, see page 58.
•
You can also restart the unit by turning it off and
on again:
–
When using the AC adaptor: Disconnect
the AC adaptor from the AC outlet, then
connect it again.
–
When using PoE: Disconnect the LAN
cable from the unit, then connect it again.

Programming the Unit

.
SELECT
.
SELECT
.
SELECT
Operating Instructions 43