Starting The Dsp Configurator Program - Extron electronics DTP CrossPoint 84 IPCP Setup Gudie

Starting the DSP Configurator Program

The DSP Configurator can connect to the switcher via any rear panel
LAN port, the rear panel Remote (RS-232) port, or the front panel
Configuration port. The program can operate at 9600, 19200, 38400, or
115200 baud rates for the Remote port.
NOTE: Extron recommends connection via an Ethernet LAN port for
the DSP Configurator program.
Start the DSP Configurator program, as follows:
1. Click Start > Programs > Extron Electronics >
DSP Configurator > DSP Configurator . The DSP Configurator
startup screen displays (see figure 15).
2 2 2 2 2 2 2 2 2 2
Figure 15. DSP Configurator Screen and Device Selection
TIP: You can also launch the DSP Configurator program from
within the Product Configuration Software.
2.
If necessary, select the DTP CrossPoint switcher in the drop-down
menu and click OK .
TIP: If you have only DTP CrossPoint switchers of the same
model, click Always
to eliminate step 2 in future startups.
The DSP Configurator program starts in Emulate mode (see
on the next page).
NOTE: In Emulate mode, changes and settings are stored
in the PC and not sent to the switcher until you select Live
mode and "push' the settings to the switcher. See the
DTP CrossPoint 84 Switcher IPCP User Guide.
28 DTP CrossPoint 84 IPCP • Remote Control
perform the selected operation
figure 16
Figure 16. DSP Configurator
DTP CrossPoint 84 IPCP • Remote Control 29