Starting The Product Configuration Software - Extron electronics DTP CrossPoint 84 IPCP Setup Gudie

4 4 4 4 4 4 4 4 4 4
Figure 12. Download Center Dialog Box
4. Enter the requested personal information;
TIP: Click Remember Me to eliminate step 4 in future downloads.
5. Click Download to copy the software or firmware to your computer.
The download warns you about downloads and asks you to confirm
it.
6. Cick Run to confirm that you want to run the installation.
7. Follow the on-screen instructions. The installation program creates
the necessary directories and folders and installs the programs.

Starting the Product Configuration Software

1. Click Start > Programs > Extron Electronics > Extron
P roduct Configuration Software > Extron Product
Configuration Software .
The Product Configuration Software opens to the Device Discovery
screen.
26 DTP CrossPoint 84 IPCP • Remote Control
5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6
1 1 1 1 1 1 1 1 1 1
Figure 13. Device Discovery Screen
TIP: You can also launch the Product Configuration Software
from the DSP Configurator program, BUT PCS can be locked
out from within DSP.
2. Select (click) your DTP CrossPoint (
1
NOTE: The default IP address is 192.168.254.254.
The Product Configuration Software opens. Operate the program
as described in the DTP CrossPoint 84 User Guide, available at
www.extron.com, and the built-in Help file.
Figure 14. Product Configuration Software
DTP CrossPoint 84 IPCP • Remote Control
2 2 2 2 2 2 2 2 2 2
) and click Connect ( ).
2
27