Fuel Hose Connection - Remote Control Models - Mercury 60 FourStroke EFI Formula Race Manual

OUTBOARD INSTALLATION
Description
Nylon insert locknut (6) (11‑826365)
Nylon insert locknut (f) (factory
installed)
1. Assemble the steering arm to the steering adapter plate (as
shown) with three flanged hexhead bolts, six hardened flat
washers, and three nylon insert locknuts.
IMPORTANT: The steering arms are stamped "STARBOARD
UP" and "PORT UP" near the cable bearing assembly of each
arm. Verify that the steering arms are in the correct location before
installing.
2. Assemble the starboard steering arm to the steering adapter
plate the same as the port side.
3. Tighten all locknuts to the specified torque.
IMPORTANT: Before each use, check the steering arm, steering
adapter plate, bearing assembly, and cable fasteners for proper
tightness.
Fuel Hose Connection ‑ Remote Control Models
REMOTE FUEL HOSE SIZE
Minimum fuel hose inside diameter (ID) is 8 mm (5/16 in.). Use a
separate fuel hose/fuel tank pickup for each engine.
FUEL HOSE CONNECTION
Fasten the remote fuel hose to the fitting with a metal hose clamp
or the plastic type hose clamp that is provided with the outboard.
a - Hose clamp
b - Remote fuel hose
Nm
27–34
27–34
a
b
28511
83
lb. in. lb. ft.
20–25
20–25