Table of Contents
Advertisement
22
Connecting Components
Installing optional devices
To access the inside of the server, remove the bezel and side
4
cover. For instructions, see "Removing and installing the
bezel and side panel" on page 24.
5
Perform any required maintenance.
CAUTION: Make sure that components handled during
system maintenance are properly installed and connections
are securely seated. Also check that no tools or hardware
items are left inside the server.
HINT: The procedures for removing and installing hard disk
drives depend on the drive type—IDE or SCSI. Be sure to
check the drive's specifications before attempting to install
or remove a drive.
Reinstall the side panel and bezel. "Removing and installing
6
the bezel and side panel" on page 24.
Reconnect all signal and power cables.
7
Turn on the server and run any required system checks.
8
Some optional devices require you to reconfigure the server's
software, change jumper, and/or DIP switch settings before
the device can be used.
In addition to the instructions in this chapter, refer to the
manufacturer's user manuals for the devices you are installing/
removing.
Advertisement
Table of Contents
