Table of Contents
Advertisement
Adding SCSI I/O devices
Installing SCSI devices on IDE HDD models requires SCSI host
adapters. To install the SCSI host adapter, refer to "Expansion
cards" on page 58.
NOTE: Installing SCSI devices requires specific technical
knowledge and experience. If you have no experience
installing SCSI devices, or if the job seems difficult, consult
your authorized service provider.
SCSI ID
The ID of the installed SCSI device must be different from the IDs
of other devices. Refer to the device manuals for more
information.
Termination
The termination setting is required for the end of the SCSI bus.
You must set the termination on the last device of the SCSI chain
or connect the terminator to the end of the SCSI cable.
Installing SCSI devices
You can install up to three 5.25-inch internal SCSI devices in the
5.25-inch device bays.
Remove the bezel and side panel. For instructions, see
1
"Removing and installing the bezel and side panel" on
page 24.
Connecting Components
Adding SCSI I/O devices
55
Advertisement
Table of Contents
