Table of Contents
Advertisement
64
Connecting Components
Connecting peripherals
CAUTION: Check that the AC outlet has a capacity adequate
for the power consumption of the server.
Never connect an air conditioner, copying machine or other
appliance that has high power consumption or generates
noise to the same AC outlets.
Turning on the server
CAUTION: After turning off the server, wait at least 10
seconds before turning it back on again. Failure to allow the
system to completely shut down may cause operation errors
or faults.
To avoid power surges, connect and turn on all peripheral
devices before turning on the server.
1
Check that the monitor, keyboard, mouse, and all peripherals
are connected correctly.
2
Connect the power supply cable to the grounded outlet and to
the connector on the server.
3
Turn on the monitor.
4
Press the server's power button.
The Power light glows green.
When you start the server, the Power On Self Test (POST) is
automatically performed. It checks the main microprocessor,
memory, keyboard, and some peripherals.
The memory test checks system memory then displays the total
amount of memory installed in the server. Depending on the your
system settings, the POST may display the "Press <Del> to enter
SETUP", allowing you to enter the setup routine.
Advertisement
Table of Contents
