Adding An Ide Hard Disk Drive - Toshiba M500D User Manual

Rotate the levers securing the memory module away from the
2
module, then lift the memory module from the connector.
HINT: Handle the module with care. The memory module
may pop out when you open the latches.
3 Reinstall the side panel and bezel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.

Adding an IDE hard disk drive

Specific technical knowledge is required to install or replace a
hard disk drive (HDD). If you are not sure how to proceed,
Toshiba recommends that you ask your authorized service
provider to install or replace HDDs.
CAUTION: Take care when handling hard disk drives. Avoid
subjecting the hard disk drive to shock or vibration. The disk
could be damaged and its data destroyed.
IDE interface
You can connect up to two hard disk drives to the primary IDE
interface on the server's system board. The first hard disk drive is
the assigned "primary" or "master" and the second drive is the
"secondary" or "slave."
In the Toshiba M500D, the primary hard disk drive is connected as
the master drive the primary IDE interface and the CD-ROM drive
is connected as the master drive on the secondary IDE interface.
Connecting Components

Adding an IDE hard disk drive

37