Brother Operating Instructions Basic User's Manual page 86

Error Message
Out of Memory
Out of Memory
Secure Print Data
is full. Press
Stop Key and
delete the
previously stored
data.
Print Unable XX
Registration failed. Registration failed.
Replace Belt
1
Replace DrumX
1
(X ) shows drum unit
color that must be
replaced. BK=Black,
C=Cyan,
M=Magenta,
Y=Yellow.
74
Cause
The machine's memory is full.
The machine's memory is full.
The machine has a mechanical
problem.
It is time to replace the belt
unit.
It is time to replace the drum
unit.
The drum unit counter was not
reset when a new drum was
installed.
Action
Reduce the print resolution.
(See Software User's Guide.)
Press and delete the previously stored
secure print data.
Do one of the following:
 Press and hold down
machine off, wait a few minutes, and then
turn it on again.
 If the problem continues, call Brother
Customer Service.
Press OK and try again.
 Press and hold down
machine.
Wait a few seconds, then turn it on again.
Perform the auto color registration using
see Advanced User's
the Touchscreen (
Guide
: Auto Registration).
 Put in a new belt unit (see Replacing the
belt unit on page 60).
 If the problem continues, call Brother
Customer Service.
Replace the belt unit (see Replacing the belt
unit on page 60).
Replace the drum unit for the color indicated on
the Touchscreen (see Replacing the drum
units on page 55).
Reset the drum unit counter. (see Resetting the
drum counter on page 60).
to turn the
to turn off the