Troubleshooting; Sit Nova 820; Honeywell; Sit Proflame 2 - Montigo H38DF PRC Installation & Maintenance Manual

H*38DF PRC Panorama Indoor Gas Fireplace
Section:

Troubleshooting:

SIT Nova 820:

The following is a troubleshooting chart of possible problems:
PROBLEM
Noisy Pilot Flame
Pilot won't ignite
Main burner will not light

Honeywell:

The following is a troubleshooting chart of possible problems:
Page 38
Maintenance
CORRECTIVE ACTION
Locate pilot adjustment screw
on gas control valve. Flame
is decreased by turning
adjustment screw clockwise.
Disconnect remote wires and
try to light pilot. If pilot now
works, remote connections
are faulty. Check wiring
diagram figure 18.
1. Check wiring (see figure 18).
2. Check wall switch for proper
connection.

SIT Proflame 2:

The following is a troubleshooting chart of possible problems:
PROBLEM
Pilot Igniter won't spark
Pilot Igniter sparking, but
Pilot burner will not light
Pilot lights , but Main
burner will not Light
Pilot lights , but Main
burner will not Light and
igniter continues to spark
Fans not working
If your fireplace still does not operate correctly, consult your
local Montigo dealer.
All service and repairs should be performed by a
qualified Technician.
All spare parts, optional fans, and optional trim finishes are
available from your local Montigo dealer.
SOLUTION
1. Check the MAIN ON-OFF switch
(typically located below the valve
cover) and turn ON
2. Ensure main power is ON or new
batteries are installed in the remote
control and backup battery pack (if
available).
3. Check the 3.15A fuse in the control
box and replace if necessary
1. Verify the Inlet and Manifold Gas
Pressure are within acceptable limits
2. Check all connections to gas valve
3. Check connection to stepper motor
(if available)
1. Check and verify all wiring
connections as per the wiring
diagram.
2 . Verify the inlet and Manifold
Pressure are within acceptable limits
1. Check the Pilot Flame Sensor Rod
and clean with steel wool or similar.
2 . Check the Pilot hood and clean
with steel wool if dirty.
3. Adjust pilot flame using the pilot
adjustment screw if the pilot flame is
too long or too short (Flame should
fully engulf the sensor rod and must
be stable).
4. Check and make sure the ground
wire from the pilot is connected to
the fireplace body.
1. Ensure main power is ON (fireplace
may be operating on back up
batteries).
2. Check the 3.15A fuse in the control
box and replace if necessary
XG0211 - 151126