Montigo H38DF PRC Installation & Maintenance Manual page 35

Disabling Thermostat
Some jurisdictions and bedroom installations require the
thermostat to be disabled.
1. Partially take out one battery, see Figure 30j.
2. Insert the battery while holding down the thermostat button.
The remote screen will display 'Clr' while the button is held
down. See Figure 30k.
3. To enable thermostat repeat steps 1-2. The remote screen
will display 'set' while the thermostat button is held down.
Figure 30j.
Figure 30k.
XG0211 - 151126
Operation
Fan Speed Control
The fireplace is equipped with optional hot air circulating fans.
The speed of the fans can be controlled by the Proflame system.
The fan speed can be adjusted through six (6) speeds. To
activate this function use the Mode Key, see Figure 30, to index
to the fan control icon, see Figure 30l. Use the Up/Down Arrow
Keys to turn on, off, or adjust the fan speed. A single "beep" will
.....
confirm reception of the command.
...
Figure 30l. Fan Speed Control
Accent Light Control
If the fireplace is equipped with variable accent lights. The
accent light function controls the Accent Lights. To activate this
function use the Mode Key, see Figure 30, to index to the accent
light icon, see Figure 30m.
Pressing the Up Arrow Key will turn the light on at the lowest
setting. Continue pressing up to get brighter. Pressing the
Down Arrow Key will turn the lights down until you get to the
off position. A single beep will confirm the reception of the
command.
Figure 30m. Light Control
H*38DF PRC Panorama Indoor Gas Fireplace
Section:
Page 35