Section 8: Installing The Accessories - Montigo Divine H34VO E Series Installation & Maintenance Manual

Outdoor residential gas fireplace
Hide thumbs Also See for Divine H34VO E Series:
Table of Contents

Advertisement

Divine Outdoor Gas Fireplace
Section:
Installing the H34VON Log Set
Installing the Logs:
The H34VON fireplace is supplied with five ceramic fibre logs. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous instruction.
Air Inlets
Pilot Assembly
Fireplace Base
Figure 8a. H34VON*'s Fireplace Base.
Step 2. Install Bottom Rear log as shown in Figure 8b.
Rear / Bottom Log
Log stand
Fireplace Base
Figure 8b. Bottom/Rear log placement.
Step 3. Install Both front base logs, (Figure 8c) on the log stands
provided. See Figure 8b.
Notch
Front Lef t
Base Log
Fireplace Base
Figure 8c. Front base logs placement.
NOTICE
If logs are not placed properly, excessive sooting will result.
Page 12
Installation
Installation
Notch in Log
Log stand
Notch
Front Right
Base Log

Section 8: Installing the Accessories

Step 4. Place the top left log as shown in figure 8d. A flat area is
provided on the front left log, and a notch in the Rear bottom log, as
shown in figure 27c. Install the glass door. If the flame does not
appear satisfactory, double-check the air inlet and exhaust outlet
pipe to ensure that they are unobstructed.
Top Left Log
Fireplace Base
Figure 8d. Top Left log placement.
Step 5. Place the top right log as shown in figure 8e. A notch is
provided on the front right log, and a impression in the Rear bottom log.
Figure 8e. Top right log placement.
Step 6. Start the fireplace. If the flame appears satisfactory, replace
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.
Embers
Figure 8f. Placing Embers.
Step 7. Place the Embers as shown in figure 8f. Arrange the ember
chips on top of the burner tray. Care should be taken when placing the
embers, as blocked burner ports may cause an incorrect flame pattern,
carbon deposits and delayed ignition. Also, the embers must never be
placed in a way that obstructs any of the air inlet ports, located at the
rear of the burner, as shown in figure 8a.
Notch
Top Right Log
Top Right Log
Embers
Embers
XG0150 - 140707.2

Advertisement

Table of Contents
loading

Table of Contents