Table of Contents
Advertisement
Cremson Starterkit User Manual
Chapter 2 Installation
2.2 Software Installation
Insert the provided CD-ROM, browse to the installation page for the "Modular Starterkit" and
select the Installation option for Softune Workbench. Follow the instructions in the
"Installation Guide" to unpack and install Softune Workbench for FR, as well as some
example projects and additional tools. It is recommended to use the default installation path
C:\Softune. Please use the available registration form to receive the installation password.
After the installation, you will find all language tools, the IDE and other system files within the
directory Softune\Bin. Samples for the Starterkit can be found in the Softune\sample
directory. The tools directory contains additional software tools (flashloader etc.).
Execute "FR Family Softune Workbench" from your Start-Menu.
If any errors occur during installation, remove any previous versions of Softune Workbench
from your PC and retry. Make sure you have enough disk space available and you have a
supported Windows OS installed. For more information see the provided installation
information and last-minute information.
Refer to the getting started session (next chapter) for more details on how to use Softune
Workbench for developing and debugging.
2.3 Download the debugging kernel (CPU-board F369 only)
You have to make sure that the debugging kernel is loaded to the internal flash ROM of the
MB91F369 MCU before you can use the monitor debugging features of the MB91F369 CPU
module. To do so, please follow these steps :
1. Locate the monitor debugger project in your sample-directory "MonDebADA91369". In this
project you will find the load module "mondeb\Debug\ABS\MonDeb-ADA-91369.mhx" which
you have to program to the embedded flash. If this load module should not be present, you
have to open this workspace in Softune Workbench and re-build the project to have the mhx-
file available for download.
2. To download the debugger kernel, open the provided MB91360 flash programmer
(contained in your tools-directory).
3. Select device type "MB91F365,6,7,8,9Gx"
4. Use browse to specify the above mhx file in the "file to program" field.
5. Select your COM-port (default is COM1) and any desired baudrate (default is 38400).
6. Make sure the CPU-module is switched off or in permanent reset. Now click on Automatic
Mode and immediately switch on the starterkit (or release the reset) to start the flash
programming. The flash programming sequence will be executed automatically.
CAUTION : DO NOT INTERRUPT THE FLASH PROGRAMMING OR CUT OFF THE
POWER DURING PROGRAMMING !
7. Wait until the programming sequence is finished. Reset the CPU-module after having
programmed the kernel successfully. Now your board is ready to be used with the Softune
workbench monitor debugger.
See the flashprogramming chapter for more details on how to program the embedded flash
of the MB91F369 MCU.
- 10 -
© Fujitsu Microelectronics Europe GmbH
Advertisement
Table of Contents
