Table of Contents
Advertisement
2 Installation
2.1 Hardware Installation
What you'll need :
Host : IBM(-comp) PC with Windows 9x, 2k, XP or NT ; 1 COM-port
<
Power Requirements: A power supply, capable of supporting 9-12V DC at about 1200
<
mA. Note that the power connector must be + at the shield and - in the centre.
RS232 : An 'extension' (1:1) RS232 cable with DB9 m+f connectors
<
A second VGA monitor (or any suitable display) for the graphic output
<
1. Combine the CPU-board and the graphic subboard
2. Connect the power supply
3. Switch on the board
the power-LEDs should light up
4. Connect the RS232 cable
from your PC to UART0
The board is now ready to use.
© Fujitsu Microelectronics Europe GmbH
Cremson Modular Starterkit
Chapter 2 Installation
Connect the VGA cable to the VGA monitor
or use the pin-headers for other displays
- 9 -
Advertisement
Table of Contents
