Software Installation - Fujitsu SK-91460T-144PMC-GPIO User Manual

2.4 Software Installation

2.4.1 Installation of Softune Workbench
With the "SK-91460T-144PMC-GPIO" Fujitsu supplies a full working development
environment called Softune Workbench V6. To develop own software the Softune
Workbench development environment must be installed first. Follow the instructions for
successful installation of the Softune Workbench.
1) Before starting the installation setup ensure that you are logged in with administrator
or poweruser permissions, otherwise the Softune Workbench installation will fail! Be
aware that Softune Workbench does not support multi-user support. Therefore
install- and user login must be the same.
2) Browse on the Micros DVD-ROM to "Software Registration". After your free online
registration you will receive your password by email.
3) Browse on the Micros DVD-ROM to "Software and Utilities" for installation Softune
Workbench.
4) Follow the installation instructions.
5) For the default installation path it is recommended to use c:\Softune6.
6) After the installation is finished. The FR Family Softune Workbench can be started
via the Windows "Start" menu.
Figure 2-2: Softune Workbench Start Menu Location
7) When Softune Workbench was started the following window will be shown.
© Fujitsu Microelectronics Europe GmbH
SK-91460T-144PMC-GPIO User Guide
Chapter 2 Installation
Figure 2-3: Softune Workbench V6 IDE
- 13 - FMEMCU-UG-910074-11