Starterkit Limitations - Fujitsu CREMSON MODULAR STARTERKIT User Manual

Checklist for project configuration :
•
Make sure, the corect Target MCU ("Project – Setup Project - MCU" menu)
MB91F369 or MB91F362 is selected as the target MCU device.
•
Use the correct linker settings as outlined above depending on your target MCU and
the target area (embedded flash or external debugging RAM).
•
Make sure to not overwrite the "security vector" (0x0FFEF4) – see hardware manual.
•
Use the provided templates to make sure the sections are located correctly.
•
Always check the "map file" (use the context menu in the project-view and select
"open list file") to see the used sections and addresses !

7.3 Starterkit limitations

If creating new projects, be sure not to use the following functions, which are reserved for
the Starterkit:
MB91F369 CPU-Board :
< Chip Selects :
CS0 is used for the external debugging RAM
CS2 is used for the external flash
CS3, CS4, CS5 are used for the graphic controller
< Memory area 0x0F:4000...0xF7:FFFF (embedded flash) is used by debugging kernel
< Memory area 0x9F:E000...0x9F:FFFF (external RAM) is used by debugging kernel
< Port N used for LEDs
< UART0 used for monitor debugger and flash programming
< External Interrupt 0 (used for Abort function)
MB91F362 CPU-Board :
< Chip Selects :
CS2 is used for the external flash
CS3, CS4, CS5 are used for the graphic controller
< Port J used for LEDs
< UART0 used for flash programming only
© Fujitsu Microelectronics Europe GmbH
Cremson Modular Starterkit
Chapter 7 . Appendix
- 29 -