Installation - Fujitsu Flash-64P-M01 Manual

Flash-64P-M01/M09

2.0 Installation

Carefully remove the board from the shipping carton. Check first if there are any
damages before power on the evaluation board.
Note: For the power supply a DC input voltage of about 7,5V is
recommended. The positive voltage (+) must be connected to the shield, and
ground (GND) must be connected to the centre of the connector X1!
After power-on, the green power-on LED should be on. If the LED is not on,
switch off the power supply and check the default jumper settings.
By default the evaluation board is equipped with a MB90F562PF. Although the
evaluation board supports two different packages, it is not allowed to mount two
microcontrollers at the same time! Otherwise the microcontrollers and the
evaluation board could be damaged! By default the Flash-memory of the
microcontroller on the evaluation board has been programmed with a test
program. So after power on a running light for the eight user LEDs can be seen.
Furthermore a welcome string is continously output on both UART channels.
The in-circuit programming allows the user to program it's own application into
the Flash-memory. How to program the Flash memory is described in chapter 1.5,
Serial Programming Interface.
If the board is used as an emulator target board, switch off the power supply and
remove the microcontroller from the socket. Now the probe cable can be mounted
into the socket. Take care of pin 1 marking onto the socket and fix the probe cable
with screws (probe cable for QFP-64 package only). Connect the probe cable now
to the emulation pod. Check all DIP swich settings of the evaluation board and
the emulation pod before the power-on of the system.
For the power on sequence the emulator system must be switched on first, after
that, switch on the evaluation board. For the emulator setup, please look at the
corresponding user manuals for the emulator system. After the power on
sequence, the reset LED of the emulator must be off and the Vcc LED must be on.
If the Reset LED is still on check the DIP switch setting of the emulator system
and the power supply of the evaluation board.
Page 19