Remove The Chassis Cover; Install The Chassis Cover - HP ProLiant MicroServer Gen8 User Manual

Remove the chassis cover

Power down the server (on page 14).
1.
Disconnect the power cord from the AC source.
2.
Disconnect the power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable
5.
documentation for instructions.
Loosen the rear thumbscrews that secure the chassis cover.
6.
Slide the chassis cover toward the rear panel, and then lift it to remove it from the chassis.
7.

Install the chassis cover

Align the installation markers on the chassis cover with those located on the front edge of the chassis,
1.
and then slide the chassis cover back onto the server.
Operations 18