Timeout Between Decodes; Timeout Between Decodes, Same Symbol; Timeout Between Decodes, Different Symbol - Motorola Symbol LS9208 Product Reference Manual

Timeout Between Decodes

Timeout Between Decodes, Same Symbol

This parameter sets the minimum time between decodes of different symbols. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. Motorola recommends setting this above 0.4 seconds. The default for the
LS9208 is 0.6 seconds. The default for the LS9208i is 0.5 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes from
Codes that correspond to the desired timeout. Include a leading zero for single digit numbers. For example, to set
a timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error or change
a selection, scan Cancel on

Timeout Between Decodes, Different Symbol

This parameter sets the minimum time between decodes of different symbols. It is programmable in 0.1-second
increments from 0.0 to 9.9 seconds. The default is 0.2 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes from
Codes that correspond to the desired timeout. Include a leading zero for single digit numbers. For example, to set
a timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar codes. To correct an error or change
a selection, scan Cancel on
page D-4.
Timeout Between Same Symbol
page D-4.
Timeout Between Different Symbol
User Preferences 4 - 11
Appendix D, Numeric Bar
Appendix D, Numeric Bar