Replacing The Power Supply - Gateway E-4000 User Manual

7
Install the new card into the add-in slot.
You can slightly seesaw the card end-to-end to help insert the card, but
do not bend the card sideways.
8
Push the add-in card retention cover inward, then secure the add-in card
retention cover with the retention thumbscrew.
9
If you disconnected any cables, reconnect the add-in card cables using your
notes from Step 4. See the add-in card documentation for further
instructions.
10
Close the case by following the instructions in
page 110.
11
See the documentation that came with the add-in card for any special
software installation instructions.

Replacing the power supply

To replace the power supply:
1
Identify your computer case style. For more information, see
your computer case style" on page
2
Open the case by following the instructions in
page 107.
106.
www.gateway.com
Gateway Mid Tower Case
"Closing the case" on
"Identifying
"Opening the case" on
121