Replacing The Lamp And Air Filters - Epson PowerLite 830p User Manual

3. If the dirt is difficult to remove or a filter is broken, replace the
filters as described on the next page. Contact your dealer or call
Epson at (800) 873-7766 in the United States to obtain new ones.
In Canada, please call (800) 463-7766 for dealer referral.

Replacing the Lamp and Air Filters

The life span of the projection lamp is about 2000 hours if
in the Setting menu is set to
Brightness Control
3000 hours if
Brightness Control
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message
Replace the lamp
lamp comes on and the lamp warning light
maintain projector brightness and image quality, replace the lamp
as soon as possible.
The lamp warning light
Contact your dealer or call Epson at (800) 873-7766 in the United
States for a replacement lamp. Request part number V13H010L31. In
Canada, please call (800) 463-7766 for dealer referral.
Follow these steps to replace the lamp and air filters:
1. Turn off the projector.
2. When the
Power
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
is set to
Low
appears on the screen when the
flashes red (the lamp is burnt out).
light stops flashing, unplug the power cord.
(default), and
High
.
flashes orange. To
Maintaining the Projector
note
When you get a replacement
lamp for your projector, you
should replace the filters.
To check how long the lamp
has been in use, see
page 105.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
97