Changing The Remote Control Id - Epson PowerLite 830p User Manual

Fine-Tuning the Projector
74

Changing the Remote Control ID

To change the remote control's ID to match the projector's ID, follow
these steps:
1. Press the button on the remote control. You see it light.
ID
2. Press one of the numbered buttons on the remote control to select
the ID of the projector you want to operate.
The button's light shuts off and the new ID is registered.
ID
3. Repeat steps 1 and 2 each time you want to switch projectors.
To check the remote control's current ID, do the following:
1. Press the button twice. After a moment, the button flashes.
ID
2. Count the number of flashes; this number corresponds to the
remote control's ID. (If it doesn't flash, the ID is set to zero.)