Firewin With Reg Standard Control - Baxi Bioflo 12 kW Granite User Operating Instructions Manual

Operation

2.9.2 FireWIN with REG standard control

Switching on – Automatic operation:
1. Press the ON/OFF button
up green and a self-test is performed (see also section 2.5.2). After a successful self-test and if a setpoint is
transferred by the system control, the FireWIN automatically starts operation.
2. Set both manual switches to the „Automatic"
3. Set the operating mode switch on the REG standard control unit RAM 786 to „Automatic operation"
REG standard control unit RAM 786 (installed in the living area) is used to operate the system (set the des-
ired temperatures and operating times) – please refer to the separate operating instructions.
The time must be set on the InfoWIN (see section 2.8.1.1). The time is used for the time control of the pellet
feed, automatic heating surface cleaning and automatic ash compression.
ON/OFF button
Fig. 121 BioWIN with REG standard control
Switching off:
1. Set „Standby"
2. If the boiler has been out of service for an extended period during the summer months, press the ON/OFF
button on the InfoWIN unit.
The anti-freeze function is not active when the boiler is shut off.
Flue cleaning function:
This is operated using the InfoWIN unit – see section 2.5.6.
Emergency operation:
If the control system fails, you can use the two manual switches
button on the InfoWIN unit
water.
on the InfoWIN panel, the display lighting is switched on, the signal lamp lights
InfoWIN operating unit
operating mode on the REG standard control unit (installed in the living area).
(see section 2.5.5) to activate emergency operation to maintain heat and hot
position.
Automatic operation
Manual switch for hot water tank
Manual switch for heating
and
39
Operating mode switch
REG standard control RAM 786
on the boiler control panel and the
.The