1.3 General notes of caution
Caution / Notes
Notes on installation
Extronics Limited
1 Dalton Way, Midpoint 18, Middlewich, Cheshire, UK. CW10 0HU
Tel: +44 (0) 845 277 5000 Fax: +44 (0)845 277 4000 E‐mail: info@extronics.com Web: www.extronics.com
The devices may only be operated when fully assembled.
In hazardous areas, the devices must not be wiped or cleaned with a dry
cloth.
The device must be switched off immediately if it is likely that it can no longer
be operated safely as a result of damaging impact or general peculiarities
(such as ingress of water or other fluids, temperatures outside of the
specified range, etc.).
General statutory requirements or health and safety rules and accident
prevention guidelines and environmental laws must be adhered to (e.g. the
German Occupational Health and Safety regulation).
Users must not open the device.
Users must not make any changes to the device. Components may not be
exchanged or replaced. If non-specified components are used, explosion
protection is no longer guaranteed.
Ensure safe handling with firm footing and sufficient room for movement.
If the enclosure is in any way damaged the device must be removed from
the hazardous area immediately.
In accordance with IEC 60079-19 and IEC 60079-17, operators of electrical
installation in hazardous areas are obliged to have them serviced by qualified
electricians.
Do not insert any sharp objects into the enclosure or any other openings of
the handheld barcode scanner. Any openings at the device may not be
covered or blocked.
The device and any accessories must be properly disposed of, i.e. as legally
specified, for example by a certified company.
Electrical plants are subject to certain regulations concerning installation and
operation (e.g. RL 99/92/EG, RL 94/9EG, or the national rules such as
IEC 60 079-14 and VDE 0100).
In the hazardous area it is the operator's responsibility to carry out any repair
and maintenance in compliance with applicable rules.
4
Need help?
Do you have a question about the iSCAN101 and is the answer not in the manual?