extronics iSCAN101 Operating Instructions Manual page 6

Caution
on laser devices
Maintenance
Servicing
Repairs
The device is closed ex-factory. It may only be opened in the factory by specifically trained personnel.
Software installation
Operation
Extronics Limited
1 Dalton Way, Midpoint 18, Middlewich, Cheshire, UK. CW10 0HU
Tel: +44 (0) 845 277 5000 Fax: +44 (0)845 277 4000 E‐mail: info@extronics.com Web: www.extronics.com
Devices fitted with laser fall under standards US 21 CFR 1040.10 and EN 60825-
1. The laser's classification is stated on a plate affixed to the device. Class 1
lasers are deemed inherently safe during normal use, but users must not look
directly into the light source. The following declaration is required by American
and international laws:
Usage of control elements, adaptations or the use of procedures that differ from
these instructions may result in a dangerous exposure to laser beams.
Class 2 lasers use a visible low-voltage LED. As with any source of bright light,
such as the sun, the user should avoid looking directly into the light. Brief
exposure to a class 2 laser is deemed not dangerous.
Provided the device is operated and assembled according to instructions and the
ambient requirements are being met continuous maintenance is not necessary.
Operators of electric equipment in hazardous areas are obliged to have them
serviced by qualified electricians (IEC 60079-19 and IEC 60079-17).
Repairs may only be carried out by the manufacturer or by persons trained and
commissioned for this purpose by the manufacturer.
For instructions on how to install the software at the PC please refer to the manual
issued by SICK.
Before operating the device you must ensure that all necessary components are
available.
5