Installing Batteries; Using The Ac Adapter - Walgreens Premium Arm WGNBPA-550 Instruction Book

INSTALLING BATTERIES

1. Press down on latch
and lift the battery cover
to open the battery
compartment.
2. Install or replace 4 "AA "
sized batteries in the
battery compartment
according to the indications
inside the compartment.
3. Close the battery cover by pushing in the top end of
the battery door.
Replace the batteries if:
1. The weak battery symbol appears on the display.
2. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores. Replace
all batteries at one time (as simultaneous set). Use only
1.5V AA alkaline batteries. Remove batteries when unit is
not in use for extended periods of time. Date and time will
need to be reset if batteries are removed or replaced. Clean
contacts on battery and in battery compartment with a soft
dry cloth each time you install batteries.
Note: Batteries are hazardous waste. Do not dispose of
them together with the household garbage.
WGNBPA-550.indd 13-14 WGNBPA-550.indd 13-14
Battery
Cover
11

USING THE AC ADAPTER

Note: • Please unload the batteries when operating
with an AC adapter for an extended
period of time. Leaving the batteries in the
compartment for a long time may cause
leakage, which may lead to damage to the
unit.
• No batteries are needed when operating with
an AC adapter.
• Date and time will need to be reset if
AC adapter is unplugged and unit is without
batteries.
1. Connect the AC adapter with the AC adapter jack
as shown below.
2. Please use only the AC adapter included with this
monitor.
Connect AC
adapter here
AC Adapter
Input: 100-240V~0.2A 50/60Hz
Output: 6V DC 1A 6W Max
12
11/9/09 1:57 PM 11/9/09 1:57 PM