Installing Batteries - Walgreens WGNBPW-920 Manual

Display Symbols:
User 1: Appears when the monitor is operated by User 1.
User 2: Appears when the monitor is operated by User 2.
Weak Battery Symbol: Appears when batteries should be
replaced.
Pulse Symbol: Shows the heart rate per minute.
Wrist Positioning Guide: See page 14 for more information.
Irregular Heartbeat Detector: See page 24 for more
information.
Memory Average: Displays average of last 3 readings.
Risk Category Index: See page 23 for more information.
If and any of the following letters and numbers appear in the area that
(No Symbol)
systolic pressure should be displayed or the wrist icon appears, an error has
occured with your reading. See Troubleshooting section of this manual for more
information. M START
STOP
Measurement Error: Wrap the cuff correctly and keep wrist
steady during measurement. Measure again.
Air Circuit Abnormality: Measure again.
Pressure Exceeding 300 mmHg: Switch the unit off to clear,
then measure again.
Error Determining Measurement Data: Measure again.
System Error: Measure again.
11

INSTALLING BATTERIES

1. The battery cover is located along
the side of the monitor. Remove
battery cover by pressing down
and pulling away from the
monitor.
2. Install batteries according to
the polarity indications inside
the compartment (as shown
in Figure 2). Battery Type: 2
Alkaline LR03 (AAA) size
3. Insert the other battery,
according to the polarity
indications inside the
compartment (as shown in
Figure 3).
4. Replace the cover by inserting
it back into place.
1.
2.
3.
4.
12