Installing Batteries - Walgreens WGNBPW-915 Manual

Display Symbols:
Weak Battery Symbol: Appears when batteries
should be replaced.
Pulse Symbol: Shows the heart rate per minute.
Irregular Heartbeat Detector: See page 21 for
more information.
Risk Category Index: See page 20 for more
information.
(No Symbol)
If and any of the following letters and numbers
appear in the area that systolic pressure should be
displayed, an error has occurred with your reading.
See Troubleshooting section of this manual for more
information.
Measurement Error: Wrap the cuff correctly and
keep wrist steady during measurement. Measure
again.
Air Circuit Abnormality: Measure again.
Pressure Exceeding 300 mmHg: Switch the unit
off to clear, then measure again.
Error Determining Measurement Data: Measure
again.
System Error: Turn off monitor and measure
again. If 'EP' error still appears on the display,
please call a Consumer Relations representative.
11

INSTALLING BATTERIES

1. The battery cover is located along the side
of the monitor. Remove battery cover by
pressing down and pulling away from the
monitor.
2. Install batteries according to the polarity
indications inside the compartment (as
shown in Fig. 2). Battery Type: 2 Alkaline
(LR03) "AAA" size.
3. Insert the other battery, according to the
polarity indications inside the compartment
(as shown in Fig. 3).
4. Replace the cover by inserting it back
into place.
Replace the batteries if:
• The weak battery symbol appears on
the display.
• Nothing appears on the display when the
power is switched on.
1.
2.
3.
4.
12