Walgreens Premium Arm WGNBPA-550 Instruction Book page 10

1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the
metal D-ring in order to form a loop. The smooth
side without the felt material should be on the
inside of the cuff loop.
End of cuff
D-ring
2. Plug the cuff tube into the left side of the unit.
Insert plug here
WGNBPA-550.indd 19-20 WGNBPA-550.indd 19-20
17
3. Open the arm cuff so that your arm may be placed
through it.
4. Remove tight fitting clothing from your upper left
arm so that the cuff can be wrapped around your
exposed arm.
5. Position cuff edge 0.8-1.2
inches (2-3cm) above elbow.
6. Center tube over middle of arm.
7. Pull the end of the cuff so that it tightens
evenly around your arm. Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between the
cuff and your arm.
8. Lay your arm on a table (palm upward) so
the cuff is at the same height as your heart.
Make sure the tube is not kinked.
18
11/9/09 1:57 PM 11/9/09 1:57 PM