18
SERVICE WORK ON THE ENGINE
18.5
Filling in gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
18.6
Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
The gear oil level should only be added when the engine is cold.
Main work
–
Remove screw cap
Gear oil
–
Mount and tighten the screw cap.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
B01670-11
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Remove the gear oil monitoring screw
B01669-10
–
Remove screw cap
–
Fill in gear oil until it emerges from the drilled hole of the gear oil monitoring
screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check
–
B01670-10
Mount and tighten screw cap
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
and fill in gear oil.
0.80 l (0.85 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 86)
.
p. 101)
.
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
Engine oil (15W/50) (
.
M6
10 Nm (7.4 lbf ft)
88
p. 101)