Emptying The Carburetor Float Chamber - KTM Freeride 250 R Owner's Manual

17 TUNING THE ENGINE
17.5

Emptying the carburetor float chamber

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Store fuel properly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
Info
Carry out this work with a cold engine.
Water in the float chamber results in malfunctioning.
Guideline
Choke function deactivated – The choke lever is pushed in to the stop. (
Idle speed
–
Turn idle air adjusting screw
drop.
–
Note the position and turn the idle air adjusting screw slowly counterclockwise until
the idle speed falls.
–
Adjust to the point between these two positions with the highest idle speed.
Info
If there is a big engine speed rise, reduce the idle speed to a normal level
and repeat the above steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle air adjusting screw to the end without any change of
engine speed, you have to mount a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.
Preparatory work
–
Turn handle
Fuel no longer flows from the fuel tank to the carburetor.
Main work
–
Place a cloth under the carburetor to capture the draining fuel.
–
Remove fitting
–
Fully drain the fuel.
–
Mount and tighten the screw plug.
B01672-10

slowly clockwise until the idle speed starts to

of the fuel tap to the OFF position. (Figure B01660-10

.
1,400... 1,500 rpm
84
p. 15)
p. 15)