Tally Xpress T9412i Network User's Manual page 13

Installing the NIC
1. Remove the two screws from the metal plate behind the
interface slot, and discard the metal plate
2. Remove the NIC from its protective bag
NIC only by its edges.
WARNING! Before installing the NIC, discharge
static electricity from your body by touching
something metal, such as the metal back plate on any
device plugged into a grounded power source. If you
walk around before finishing the installation,
discharge any static electricity again.
A
D
3.
4.
.
(A)
5.
. Handle the
(B)
6. Tighten the two screws on the side cover
B
E
Insert the NIC into the controller board NIC socket
Use the screws removed in Step 1 to fasten the NIC in
place .
(D)
Making sure the wire-snaps on the parallel port are not in
the way, align the side cover bottom edge with the
bottom edge of the printer (about
and slide it towards the front
C
F
Installing the Network Interface Card (NIC)
.
(C)
3
⁄ inch to the back),
4
.
(E)
.
(F)
7