Tally Xpress T9412i Network User's Manual page 12

Preparing the Printer
1. Turn off the printer
(A)
2. Remove the power cord from the back of the printer,
disconnect the printer cables from the ports
Position the printer so you are facing the side and back
corner where the cable port is located. Make sure you
have enough room to work.
3. Remove the two screws from the side cover
4. Slide the side cover approximately
back of printer using the handle on the side cover.
(E)
A
D
6 Chapter 2, Installing the NIC
.
.
(B,C)
.
(D)
3
⁄ inch towards the
4
B
E
Making sure the wire-snaps on the parallel port are not in
the way, rotate the side cover away from the printer
1
approximately ⁄ inch.
4
5. Lift the side cover off the printer
connect to a Macintosh, install the PostScript SIMM and
8MB SIMM included in your Network upgrade Kit. See
the instructions included in the kit or consult the Xpress
T9412i User's Guide.
WARNING! Avoid touching the controller board
circuitry and components.
C
F
. If you are going to
(F)