Table of Contents
Advertisement
PV 35A
3.
Operation
3.1
Application
3.2
Recommended Fuel
3.3
Starting the Engine
See Graphic: wc_gr004492
3.3.1
3.3.2
3.3.3
3.3.4
3.3.5
3.3.6
wc_tx000754gb.fm
This machine is intended for on-site vibration of concrete for
foundations, walls, columns, slab work, etc. The self-contained design
allows free movement about the jobsite without the restrictions of an
electrical cord.
The engine requires regular grade unleaded gasoline. Use only fresh,
clean gasoline. Gasoline containing water or dirt will damage fuel
system. Consult engine owner's manual for complete fuel
specifications.
If engine is cold, move the choke lever (a) to the CLOSED position
(a1). If engine is hot, set the choke to the OPEN position (a2).
Press the priming bulb (b) repeatedly until fuel can be seen in the clear
plastic fuel return tube (c).
Turn the engine switch to the ON position (d1).
Pull the starter grip (e) lightly until you feel resistance, then pull briskly.
Return the starter grip gently.
Gradually open the choke as the engine warms up (a2).
Open the throttle fully to operate equipment. (See "Operating the
Machine" for more information.)
12
Operation
Advertisement
Table of Contents
