Sharp AR-280 Service Manual page 92

3 - 6
Purpose Adjustment
Function Used to adjust the finisher stacking capability. (Used to
(Purpose) adjust the stop position of the finisher paper width di-
rection alignment plate (jogger). This adjustment is
made by changing the width direction alignment plate
home position by the software.)
Section Finisher
Item Operation
Operation/ 1. Select B mode with [­] and [¯] keys.
Procedure
2. Select the paper size by entering the numbers
(0 or 1) with the 10-key pad.
3. Select A mode with [­] and [¯] keys.
4. Enter the adjustment value with the 10-key pad.
5. Press the [EXECUTE] key.
The value entered in procedure 4 is set.
The finisher's jogger starts operation. During operation, the [EXE-
CUTE] key is highlighted.
If the [EXECUTE] key is pressed while it is highlighted, the load
operation is interrupted.
4
4 - 2
Purpose Operation test/check
Function Used to check the operation of sensors and detectors
(Purpose) in the paper feed section (desk feed, large capacity
tray) and the related circuit.
Section Paper transport
Item Operation
Operation/ The operting conditions of the sensors and detectors in
Procedure the paper feed section are displayed.
The active sensors and detectors are highlighted.
Desk Unit Sensor
DDOPSW Door open sensor
DPOD1 Paper exit transport sensor 1cs
DPOD2 Paper exit transport sensor 2 cs
DPOD3 Paper transport sensor 3cs
DLUD1 1cs Lift upper limit sensor
DPED1 1cs Paper empty sensor
DCSPD1 1cs remaining quantity detection 1
DLUD2 2xs lift upper limit sensor
DPED2 2cs paper empty sensor
DCSPD2 2cs remaining quantity detection 1
DLUD3 3cs lift upper limit sensor
DPED3 3cs paper empty sensor
DCSPD3 3cs remaining quantity detection 1
FOUND1 1cs lift unit detection (Installation detection)
FOUND2 2cs lift unit detection (Installation detection)
FOUND3 3cs lift unit detection (Installation detection)
DCSS11 1cs size detection 0
7/13/2000
DCSS12 1cs size detection 1
DCSS13 1cs size detection 2
DCSS14 1cs size detection 3
DCSS21 2cs size detection 0
DCSS22 2cs size detection 1
DCSS23 2cs size detection 2
DCSS24 2cs size detection 3
DCSS31 3cs size detection 0
DCSS32 3cs size detection 1
DCSS33 3cs size detection 2
DCSS34 3cs size detection 3
LCC Unit Sensor
LRE Remaining quantity sensor
LUD Upper limit sensor
LDD Lower limit sensor
LPED Paper empty sensor
LPFD Paper exit sensor
LDSW Door open SW
LTOD Body connection sensor
LCD Cassette detection line
4 - 3
Purpose Operation test/check
Function Used to check the operation of the loads in the paper
(Purpose) feed section (desk paper feed, large capacity tray) and
the control circuits.
Section Paper transport
Item Operation
Operation/ 1. The names of the loads which can be operated are
Procedure displayed.
Select the load to be checked with the key, and the
selected load is highlighted.
2. Press the [EXECUTE] key.
The load selected in procedure 1 starts the operation.
During the operation of the load, the [EXECUTE] key is highlighted. If
the [EXECUTE] key is pressed while it is highlighted, the operation is
stopped.
7 – 11