Sharp AR-280 Service Manual page 112

(AR-287/337/407/507)
0: No connection
1: Printer controller
3: External printer controller
4: AXIS controller
8: Tandem connection (Initiator)
10: Tandem connection (Target)
20: Network scanner controller (NS1)
Either of the above values is set.
*
AR-287 is not provided with the tandem setting.
However, the display is not changed. When tandem setup is tried, it
is rejected.
26 - 46
Purpose Setting
Function Used to set the image direction or not regardless of
(Purpose) modes when the finisher/sorter is installed.
Item Specifications
Operation/ This simulation is used to set the image direction or not
Procedure regardless of modes when the finisher/sorter is in-
stalled. (Other models than AR-405/407/501/505/507)
Set value
Not set. (The image direction is changed in the
0
staple mode of FN1.)
Set. (The image direction is not changed
1
regardless of presence of the staple.)
Default: 0
26 - 50
Purpose Setting
Function Used to set YES/NO of black/white reversion is al-
(Purpose) lowed.
Item Specifications
Operation/ When this simulation is executed, the current set value
Procedure is displayed.
At that time, the set value can be changed with the 10-
key.
When the OK key is pressed, the currently set value is stored in the
EEPROM.
Default: 1 (YES) (Black/white reversion is allowed.)
0 NO: Black/white reversion is inhibited.
1 YES: Black/white reversion is allowd.
7/13/2000
Operation mode
(Common)
Set content
26 - 52
Function Used to set whether white paper discharge count up is
(Purpose) performed or not.
("White paper" means insertion paper in the OHP inser-
tion paper mode (without copy), cover paper in the
cover paper insertion mode (without copy)/back cover,
and white paper in the duplex exit mode (CA etc.).)
Operation/ When this simulation is executed, the current set value
Procedure is displayed.
Under this state, the set value can be changed with the
10-key.
When the OK key is pressed, the currently set value is stored in the
EEPROM.
Set value
0
A
1
(AR-250/280/281/285/286/335/336/405/501/505)
Destination
U.K./Europe/Aus.
Others
(AR-287/337/407/507)
Destination
Japan Australia
Others
When set to 0 (count up is nor performed), the following counters do
not count up.
·
COPIES counter
·
Total counter
·
Maintenance counter
·
Developer counter
·
Department management counter
·
The signal (PNC) for the external auditor (mechanism counter) is
not outputted.
7 – 31
Content
White paper count up is not performed.
White paper count up is performed.
Default
0 (Count up is not performed.)
1 (Count up is performed.)
Default
0 (Count up is not performed.)
1 (Count up is performed.)