Sharp AR-280 Service Manual page 109

26 - 12
Purpose Setting
Function Used to enter the Diagnosis function key input.
(Purpose) (AR-287/337/407/507)
Item Operation
Operation/ 1. After entering the sub code of the simulation, enter
Procedure the software key in the obtained frame of "NEW."
2. When the obtained number is entered with the 10-key (max. 9 dig-
its), the entered number is displayed in the frame of "NEW." After
entering the number, press the [OK] key, and the entered number
is stored.
3. The Alert/Status E-Mail send function with attached data of the
Remote E-Mail Diagnosis System is enabled.
26 - 13
Purpose Setting
Function After completion of copier job in copier interruption dur-
(Purpose) ing a printer job, the print job is resumed in synchroni-
zation with the auto clear timer (key operation) setup
time [10-240]. By making the setup below, the print job
is resumed in 0 sec. (However, the auto clear function
is enabled with the setup time of key operation. Also,
this simulation and auto clear are not synchronized.)
(AR-287/337/407/507)
Item Operation
Operation/ When this simulation is executed, the current set value
Procedure is displayed. At that time, the set value can be changed
with the 10-key.
When the [OK] key is pressed, the current set value is
stored in the EEPROM.
26 - 15
Purpose Setting
Function Used to set the fusing operation mode (paper curl cor-
(Purpose) responding mode).
Section Fixing (Fusing)
Item Operation
Operation/ Due to the paper type (paper property), paper may be
Procedure curled in the fusing section and cause a paper jam. To
prevent against this, the fusing condition is changed.
Enter the code number corresponding to the fusing condition and
press the [OK] key.
Set value Remedy mode
0 Normal operation
1 Remedy mode 1
2 Remedy mode 1
26 - 18
Purpose Setting
Function Used to set VALID/INVALID of toner save operation.
(Purpose) (This simulation is valid only in the Japan and UK ver-
sions. (It depends on SIM 26-6 (Destination setting).
For the other destinations, the same setting can be
executed with the user program.)
Item Specifications
Operation/ Enter the code number corresponding to the condition
Procedure (the toner save YES/NO) with the 10-key and press the
[OK] key.
Set value
0
1
26 - 22
Purpose Setting
Function Used to set the specification (language display) for the
(Purpose) destination. (Excluding the Japan models.)
Item Specifications
Operation/ Select the language to be used according to the table
Procedure below.
(AR-280/281/285/286/335/336/405/501/505)
Display
ENG.(US)
ENG.(UK)
FRENCH
SPANISH
GERMAN
7 – 28
Fusing condition
(Default)
a. Racing until the specified
fusing temperature is
reached.
a. Racing is performed until
the specified fusing
temperature is reached.
b. Copy mode is duplex mode
or sort.
Group mode
·
Previous rotation is made
for 5 sec before starting
copying.
Operation mode
(Common)
Toner save
YES
NO (Default)
Language
English(US)
English(UK)
French
Spanish
German
7/13/2000