Sharp AR-280 Service Manual page 35

5) Install the electrode to the original position and fix with the fixing
screw (1 pc.).
6) Insert the main charger unit completely into the copier along the
guide groove.
Transfer/separation charger unit wire cleaning
1) Slightly lift the transport section open/close lever and tilt it to the
right.
2) Remove the driver transfer separation charger fixing screw, and
remove the transfer/separation charger unit from the copier body.
AR-501/505/507: Perform the following procedure if neces-
sary.
After removing the TC charger in procedure 2), wipe the lamp
which can be seen from the square hole of the TC guide rail with
waste cloth.
3) Remove the separation charger guide from the charger case.
4) Squeeze the transfer/separation charger wire with the charger
cleaner, and move it in the direction of the arrow which is indi-
cated on the charger to clean.
5) Install the separation charger to the charger case, and insert the
transfer/separation charger unit along the guide groove com-
pletely to the bottom.
Then, tighten the transfer/separation charger fixing screw, return
the transport section open/close lever to the left, and close the
front cabinet.
D. Accessory installation
1) Tray installation
Tray
4 – 4
illust: AR-335
7/13/2000