IBM eserver xSeries 232 8668 Hardware Maintenance Manual page 66

Installing non-hot-swap drives
10. If the drive is an IDE device:
58
Hardware Maintenance Manual: Type 8668
4. If the drive that you are installing is a laser product, observe the following
safety precaution:
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result
in exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
v Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
DANGER Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following. Laser radiation when open. Do not stare into the beam,
do not view directly with optical instruments, and avoid direct exposure to the
beam.
5. Touch the static-protective package containing the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
6. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
7. Install rails on the drive.
v If you are installing a standard-size drive:
a. Pull the blue slide rails off the back of the filler panel.
b. Clip the rails onto the sides of the drive.
v If you are installing a digital linear tape (DLT) backup drive, use the metal
slide rails and screws that come in the box that contains the server
documentation.
8. Align the rails on the drive with the guide rails in the drive bay.
9. Push the drive into the bay until it clicks into place.
v Make sure the drive is not a hard disk drive.
v Plug a connector on the IDE cable into the back of the drive.
v Make sure the other end of the IDE cable is plugged into the IDE connector
on the system board.
v Go to step 12 on page 59.