Cross Folding Non-Standard Size Paper - Hefter TF MEGA-A Instruction Manual

18
Check the finish of test folding.
Check for folding misalignment using the
second test folded sample.
If folding misalignments occur, refer to
Chapter 3 "ADVANCED OPERATION""5.
Correcting Folding Misalignment"
( p.3-20).
19
After completing adjustments, set the
count mode either to the add count or
to the subtract count, then press the
key to start folding operations.
Refer to Chapter2 "Basic Operation"
"1.Standard Folding of Standard Paper" "1-3.
Operation Procedures (
20
Store the cross folding lever.
4-2.

Cross Folding Non-Standard Size Paper

Paper other than the standard size paper are called non-standard size paper. The paper size that can be cross
folded is as follows.
Maximum: 297 (W) x 432 (L) mm/11.69 (W) x 17.00 (L) inches
Minimum: 128 (W) x 182 (L) mm/5.04 (W) x 7.16 (L) inches
* Minimum for single fold: 90 (W) x 135 (L) mm/
3.54 (W) x 5.31 (L) inches
1
Fold the paper into two according to
Chapter 3 "ADVANCED OPERATION"
"3.Standard Folding of Non-Standard
Size Paper" ( p.3-11).
2
Measure the length (L) of the single-
folded paper.
p.2-2).
Chapter3 Advanced Operation
Paper feeding direction
Length:182 to 432 mm/
7.16 to 17.00 inches
Width:128 to 297 mm/
5.04 to 11.69 inches
Paper feeding direction
L
Folded sample
3-17