Chapter3 Advanced Operation; Standard Folding Of Special Paper; Single Folding Thick Paper - Hefter TF MEGA-A Instruction Manual

Chapter3 Advanced Operation

1.

Standard Folding of Special Paper

Do not put neither hands nor fingers inside the machine during operation. You also need to be
careful not to get your hair, accessories and wear caught in the machine.
1-1.

Single Folding Thick Paper

When folding fine quality thick paper 104.7 g/m
a part near the center may bend due to environmental conditions (temperature, humidity), paper size, paper
fiber direction, etc. When this occurrs, follow the procedures below.
1
While pressing the
key to change [CF2 length] from [0.0mm]
to [0.4mm](EU)/[0.02inch](North
America).
The folding stopper of the second folding
plate moves by 0.4 mm/0.02 inch to widen the
paper conveyance path, resulting in smooth
conveyance of thick paper.
If mis-feed or double-feed occurs, refer to
Chapter2 "Basic Operation" "1.Standard
Folding of Standard Paper" "1-3. Operation
Procedures ( p.2-2).
3
Check the finish of test folding.
Check for folding misalignment using the
second test folded sample.
If folding misalignments occur, refer to
Chapter 3 "ADVANCED OPERATION""5.
Correcting Folding Misalignment"
( p.3-20 ).
4
After completing adjustments, set the
count mode either to the add count or
to the subtract count, then press the
key to start folding operations.
Refer to Chapter2 "Basic Operation"
"1.Standard Folding of Standard Paper" "1-3.
2
/34 lb into two, the edge of the folding line of the paper or
Bent corner
Bend near the center
key, press the
Chapter3 Advanced Operation
A3 CF2 length
0.0mm
Test folded sample
3-1