Cross Folding Standard Size Paper - Hefter TF MEGA-A Instruction Manual

Chapter3 Advanced Operation
4-1.

Cross Folding Standard Size Paper

The paper size that can be cross folded is A3, B4, A4 and B5 (EU)/ LD, LG and LT (North America).
The following describes the cross single folding procedures of A3 (EU)/LG (North America) size paper.
s
Only short edge feed is available for
cross folding.
1
Fold A3 (EU)/LG (North America) size
paper into two according to Chapter
1 "BASIC OPERATION" "1.Standard
Folding of Standard Paper" ( p.2-1).
2
Press along the folded line of the single-
folded paper firmly with your fingers
to prevent the paper from slipping and
buckling in the horizontal direction
when folded.
3
Raise the paper set lever and stack the
single-folded paper on the paper feed
tray with the folded line facing the non-
operator's side.
The amount of paper stacked on the
paper feed tray should be approximately
2/3 (36 mm/1-1/2 inches) of the height of
the side guide.
4
Loosen the fixing screws of the side
guides.
5
After pressing the side guide to each
side of the paper lightly, tighten the
screws to secure the side guides.
3-14
36 mm/1-1/2 inches
Paper
Side guide
Side guide
Side guide
Paper set lever
Fixing screw
Fixing screw