6-4.4 Gas Valve Leak Test - Ace Heating Solutions Atlas A050 Operating And Maintenance Manual

5) If the flame signal is higher than 0.5 Vdc and the flame LED does come on, contact your local Ace Heating
Solutions, LLC. representative for more help.
Site-glass
Petcock
White ceramic spark rod
Gas ball-valve
Figure 6.2. Atlas Combustion Assembly Without Figure 6.3. Pilot Assembly
Burner
Figure 6.4. Voltmeter Connected to Control Panel

6-4.4 Gas Valve Leak Test

This test is to check the closure tightness of the gas shutoff valve. It should only be performed by trained, experienced,
flame safeguard technicians during the initial start up of the burner system of whenever the valve is to be replaced. This
test should also be included in the scheduled maintenance and inspection procedures. For the test below, refer to figures
6.6 and 6.7 below.
92
Rev 2.1