Configure
System Configuration
x
Select Fahrenheit to show temperature in Fahrenheit
x
Select Celsius to show temperature in Celsius
This parameter determines whether temperature is represented in units of Fahrenheit or Celsius degrees.
5-24.7 To Turn On And Off The Unit Using Burner Switch
Operation
Burner Switch Button (Default: Yes/True/On)
This parameter enables or disables the burner control. When it is off, the burner will not fire.
5-24.8 To Enable Pump Test
Diagnostics
Diagnostics Test
Enables the installer to verify that the correct pump contacts are on or off. The Start Test button will test all pump
contacts; pressing an individual pump tests that pump contact only.
5-24.9 To Enable Modulation Test
Diagnostics
Diagnostics Test
Enables the user to verify that the unit is firing at the correct rate.
5-24.10 To Enable Pilot Test
Diagnostics
Diagnostics Test
Enables the user to verify that the pilot valve is functioning properly. The installer can also perform adjustments for the
pilot flame.
Temperature Units Textbox (Default: Fahrenheit)
Pump Test Button
Modulation Test Button
Pilot Test Button
88
Rev 2.1