Configuration Password - Ace Heating Solutions Atlas A050 Operating And Maintenance Manual

Configuration parameters for the Honeywell Sola Controller (Flame Safe Guard and Operating Control) on any boiler
connected in the Global Modbus™ network can be accessed from the System Operator Interface. Press the icon of the
Honeywell Sola Controller on the Home Page to access the Status Page of each unit.
Pressing the Configure button on the Status Page starts a configuration session of the Honeywell Sola Controller.
The Configuration Page contains a menu of parameters grouped into functional areas that the user selects for
configuration as in Figure 4.6.
Figure 4.6 – Configuration Menu Page
Selecting a parameter group from the menu displays parameters exclusively applicable for the functional group on the
page. These parameters can be edited, and when the user is finished, control returns back to the configuration menu
page.
Each parameter is displayed in its group. If there are more parameters than will fit on the screen, a vertical scroll bar
allows the user to scroll up and down to view all parameters. The parameter name is displayed on the left and the current
setting is displayed in the text box on the right.

4-9 Configuration Password

Any user can view the configuration parameters. No access-level password is required to view the parameters. To change
a parameter, a valid configuration password for that parameter's level must be entered by the user before the Installer or
OEM level parameter can be changed. The password need only be entered once while the user remains on the
Configuration pages. Leaving the Configuration Pages ends the scope of the password entry. The user is notified that a
new password is needed upon the first attempt to change a parameter or until a password is entered successfully as seen
in Figure 4.8. The user can continue viewing the configuration parameters regardless of whether a password is entered
successfully.
48
Rev 2.1